西门子
11/14
Siemens KT 10.1 · 2016
11
SITOP DC UPS uninterruptible power supplies
DC UPS带电池模块
SITOP UPS1600 DC UPS模块
■
Technical specifications
The table shows the maximum buffering times for the SITOP
UPS1100 battery modules for different load currents:
The SITOP Selection Tool offers detailed selection guidance
根据标准，如所需的备份时间，负载
current, peak current and battery connection threshold:
Important information for selecting the battery capacity:
Determination of the mains buffering times is based on the dis-
新的或非老化，完全充电电池的充电期
电池温度的模块不低于+ 25°C到关闭 -
down of the DC UPS.
电池老化
reduces the still available battery capacity up until
the end of the service life to typically around 50% of the original
新的容量值（1.2 ah / 3.2 ah / 7啊等）和in-
Ternal阻力增加。当消息“电池充电时
> 85%" appears, only around 50% x 85% = approx. 43% of the
最初可用的容量可以在结束时假设
battery service life.
At battery temperatures below +25 °C, the available capacity
drops approximately by another 30% at +5 °C battery tempera-
Ture，约占剩下的43％的70％。
那时只有大约30％的原始容量可用。
因此必须选择明显更大的电池容量
when configuring the plant: A drop to approx. 50% is compen-
sated for by selecting 1 / approx. 0.5 = approx. double the
电池容量（根据相关负载的表格所需
current and the relevant buffering time). Available capacity of
约。通过选择1 /约43％来补偿。
0.43 =约。电池容量2.33倍。可用的电容 -
ity of approx. 30% is compensated for by selecting 1 / approx.
0.3 = approx. 3.33 times the battery capacity.
推荐：
而不是安装双电池容量，常规电池
replacement halfway through the expected service life (reduc-
容量约为。50％）可以更为建议
following reasons: Capacity does not drop below 100% until the
halfway point of the expected battery life (or slightly beyond).
With regular replacement after this point, only the single battery
capacity (instead of double capacity) must be installed due to
老化（ - >价格在价格上的电池模块成本，
但只需要一半的空间）。
在其使用寿命的一半之后更换电池
all with the large scatter range of the residual capacity at the end
of the service life, which is not accurately defined by battery
制造商（在全职后，很多电池都在上面，但是
许多人也低于平均50％的剩余容量，即
to say, even if double the capacity is installed, the influence of
aging at the end of service life is not reliably compensated for,
而不是通常） - >在预期的一半后替换时
service life, the configured buffering time is maintained with
相当大的可靠性。
In the case of batteries stored in cool conditions (not above
+ 25°C）和不超过约4个月，
following service life can be assumed, strongly dependent on
battery temperature:
在正常情况下（安装在控制中最酷的位置
机柜约。+30°C），电池应更换
single installed battery capacity in accordance with the selection
table after 1 year of operation!
After a power failure, the battery module is disconnected from
the loads at the end of the selected buffering time either auto-
matically or electronically by opening the On/Off control circuit,
一旦再次使用24 V输入电压，就可以使用
快速重新收取相关DC的充电电流
UPS模块(i服了u电荷特性:第一constant
current I for fast charging, and changeover to constant voltage
U to maintain the charge when the battery is almost full).
产品品牌
name
SITOP UPS1100
SITOP UPS1100
SITOP UPS1100
SITOP UPS1100
SITOP UPS1100
SITOP UPS1100
电力类型
supply
24 V / 1.2啊
24 V / 2.5啊
high temperature
24.V/3.2 Ah
24.V/5 Ah LiFePo
24.V/7 Ah
24.V/12 Ah
文章号
6ep4131-0GB00-0AY0.
6ep4132-GB00-0AY0.
6.EP4133-0GB00-0AY0
6.EP4133-0JB00-0AY0
6.EP4134-0GB00-0AY0
6.EP4135-0GB00-0AY0
负载电流
Buffer times
1 A.
3.4.min
1.7小时
2.5 H.
5.2 H.
5.4 H.
10.3 H.
2A
15分钟
5.4.6分钟
1小时
2.5 H.
2.6 H.
4..8 h
3.A
9.min
32.9分钟
3.9.min
1.7小时
1.6 H.
3.h
4.A
6分钟
20.6分钟
27分钟
1.25 h
1.2 h
2.3 H.
6.A
3.5分钟
14..3 min
17..5 min
50.6分钟
41分钟
1.4 h
8.A
2min
10.5 min
12分钟
3.7..8 min
28分钟
1小时
10 A
1min
7..2 min
9.min
30.2分钟
22分钟
4.8..6 min
12A
-
6分钟
7.min
25.1分钟
17.min
40.3分钟
14 A.
-
4.5分钟
5分钟
21.6分钟
15分钟
3.3..6 min
16 A.
-
4..1 min
4.min
18..8 min
12.5分钟
26.min
20 A
-
2.9 min
1min
12.9 min
9..1 min
19..6 min
3.0 A
-
-
-
-
4.6分钟
12.1 min
4.0 A
-
-
-
-
2.8 min
8.5分钟
Battery
temperature
Drop to approx.
5.0% of residual
capacity
推荐 -
tion: Replace
(at 100% of
剩余的
容量）全部
选择
推荐
+ 20°C.
4年
2年
+ 30°C.
2年
1year
+ 40°C.
1year
0.5岁
安装双倍
能力和
replace
(1 x per year)
© Siemens AG 2016