SIEMENS
2/16
Siemens NC 82 · 2017
Overview of functions
CNC controls SINUMERIK 828
Operating modes
2
Operating modes
(continued)
Teach-in:
Included in option:
Extended operator
功能
6FC5800-0AP16-0YB0
• Turning
O
O
O
• Milling
O
O
O
• G-Tech Cylindrical/G-Tech Surface
O
O
–
Automatic:
• Execution from storage medium connected to CompactFlash card
interface on the operator panel front
• Execution from storage medium connected to the front USB interface
of the operator panel, e.g. card reader, USB flash drive
Hard disk not possible
• Execution from storage medium connected to the rear USB interface
of the operator panel, e.g. card reader, USB flash drive
Hard disk not possible
• Execution from network drive
Included in option:
Network drive manage-
ment via Ethernet
6FC5800-0AP01-0YB0
O
O
O
O
• Program control
• Program editing
• Overstore:
Included in option:
Extended operator
功能
6FC5800-0AP16-0YB0
- Turning
O
O
O
- Milling
O
O
O
-
G-Tech Cylindrical/G-Tech Surface
O
O
–
• DRF offset:
Included in option:
Extended operator
功能
6FC5800-0AP16-0YB0
- Turning
O
O
O
- Milling
O
O
O
-
G-Tech Cylindrical/G-Tech Surface
O
O
–
• Block search with/without calculation
• Extended block search
program, search pointer, step up and down,
interrupt function:
Included in option:
Extended operator
功能
6FC5800-0AP16-0YB0
- Turning
O
O
O
- Milling
O
O
O
-
G-Tech Cylindrical/G-Tech Surface
O
O
–
Repos (repositioning on the contour):
• With operator command/semi-automatically
• Program
Preset:
• Set actual value
Basic version
O
Option
–
Not available
Article No.
SINUMERIK 828D
BASIC
Note
SW 24x
SW 26x
SW 28x
SW 28xA
© Siemens AG 2016