西门子
Description of options
SINAMICS GM150 SINAMICS SM150
Description of options
6/14
西门子D 12·2012
6
■
选项s
笔记：
根据选项对静态激发单元的接受测试
F03
，，，，
F73
和
F77
只能与转换器一起
which must be ordered simultaneously.
In general, a high voltage test of the converter is already
在类型测试期间执行。当测试重复为
part of option
F77
，测试电压降低至80％（Accors-
到DIN EN 61800-5-1/VDE 0160 T105（IEC 61800-5-1））。
激发单元仅作为选项的一部分接受
F97
when
此选项同时为转换器选择
excitation unit and is generally performed at another location
和at another time.
F28, F72, F76
变换器交流ceptance tests without the customer present
The acceptance scope of these options corresponds to that of
options
F29, F73
或者
F77
但是，没有客户
当下。
选项
Description
F97
特定于客户的系统接受测试（应要求）
For a system acceptance test, transformer (if technically required), converter, cooling system (if technically required) and motor should be
设置并委托。转换器，冷却系统和变压器直接彼此安装，但与
马达。
Only already pre-tested components (together with a test certificate) are subject to a system test.
下面列出了在系统测试中心中可以执行的测试。对于每个系统接受测试，实际测试
scope must first be coordinated with the Siemens contact person.
温度升高测试
Full load test run or partial load test run of the motor in converter operation until the temperature reaches its steady-state level.
The operating point should be preferably selected where the highest temperature increases is expected (
m
n
，，，，
n
n
）。电阻法
is the basis for determining the temperature rise. During the temperature-rise test, in addition to the motor temperatures, the electrical
完整驱动系统的操作参数也连续记录。
负载测试
•在四个不同操作点上的负载点
• The system efficiency is determined at the defined load points
•线侧谐波分析
其他测试
•高压绝缘测试：
The converter and motor have already been tested as part of the routine tests performed during production. Re-testing the converter is
time-consuming and is not recommended. It can only be performed as part of a test that is separately performed for options
F73/F77
。
• Converter function test:
使用定义的仿真例程检查故障和警报功能（例如，过时的旅行，紧急停车，过电流，
超速，欠压）
•120％超速测试
•噪声测量（从转换器中馈入电动机，没有负载）
• Vibration measurement (motor fed from the converter without load)
• Visual inspection (converter and motor and where relevant, transformer)
© Siemens AG 2012