SIEMENS
5/7
Siemens D 11 · 2015
5
Tools and configuration
STARTER commissioning tool
■
Selection and ordering data
Note:
In addition to the STARTER commissioning tool, SINAMICS Drive
Control Chart (SINAMICS DCC) can be installed. This allows the
device functionality in the SINAMICS drive system to be ex-
panded with technology functions as required.
更多的信息about SINAMICS DCC can be found in section
"SINAMICS Drive Control Chart (SINAMICS DCC)".
Accessories
Depending on the version of the Control Unit (CU), the Control
Unit of the drive unit can communicate with the programming
device (PG) or PC via PROFIBUS or PROFINET/Ethernet or via a
serial interface. The following accessories are available for the
particular drive system as listed in the following table.
■
更多的信息
The STARTER commissioning tool is also available on the
Internet at
/starter
Description
Article No.
STARTER commissioning tool
for SINAMICS and MICROMASTER
English, French, German, Italian, Spanish
6SL3072-0AA00-0AG0
Description
Recommended accessories
For communication between
the drive unit and the pro-
gramming device or PC
Article No.
SINAMICS G130 and SINAMICS G150
• PROFIBUS
CP 5711 communication
module
USB adapter for connect-
ing a PG or notebook to
PROFIBUS or MPI
USB cable (2 m (6.56 ft))
included in scope of supply
6GK1571-1AA00
SIMATIC DP plug-in cable
12 MBaud, for PG connec-
tion, pre-assembled with
2 × 9-pin SUB D connector,
3 m (9.84 ft)
6ES7901-4BD00-0XA0
• PROFINET/
Ethernet
Standard CAT5 Ethernet
cable or PROFINET cable
–
© Siemens AG 2015