SIEMENS
4/24
Siemens D 11 · 2015
■
选项
（继续）
4
SINAMICS G150
Drive converter cabinet units
75 kW到2700 kW
L50
带服务插座的橱柜照明
With option
L50
，额外的橱柜照明灯
service socket for a SCHUKO connector (connector type F)
根据CEE 7/4。机柜照明的电源
and the service socket is external and must be fuse-protected
for max. 10 A.
The cabinet lighting consists of an LED hand lamp with On/Off
开关和磁性紧固件约。3米长
necting cable. The lamp is factory-positioned in the cabinet door
在定义的标记处，连接电缆缠绕在
associated mount.
L55.
Anti-condensation heating for cabinet
The anti-condensation heating is recommended at low ambient
temperatures and high levels of humidity to prevent condensa-
tion. A 100 W cabinet heater is installed in each cabinet section
(two heaters are installed per cabinet with cabinet section widths
在800 mm和1200 mm之间）。
防冷凝加热的电源（110 V至
230 V AC，在端子块-X240处）必须在外部提供
and fused with max. 16 A.
L57.
紧急关闭类别0,230 V AC或24 V DC
EMERGENCY OFF Category 0 for uncontrolled stopping
according to EN 60204-1.
The function includes interrupting the power supply for the con-
Verter通过线路接触器并绕过微处理器
controller using a safety combination according to EN 60204-1.
The motor coasts to a standstill. When delivered, the pushbutton
电路预设为230 V AC。跳线必须适当设置
使用24 V DC时。
注意：
Option
L57.
always requires electrical separation from the line
供应,这意味着一个中国保监会的转换器uit, for converter
currents
≤.
800 A，选择
L13
and for converter currents > 800 A,
选项
L26
. For converters with power units connected in paral-
lel, electrical separation from the line supply is included as stan-
达德。
L59.
紧急停止类别1,230 V AC
EMERGENCY STOP Category 1 for controlled stopping accord-
ing to EN 60204-1.
The function stops the drive using a fast stop along a down ramp
由用户参数化。电源给了
然后按照紧急情况进行中断验证器
类别0。
为了保持指定的停止时间，它可能是
necessary to use a braking unit.
注意：
Option
L59.
always requires electrical separation from the line
供应,这意味着一个中国保监会的转换器uit, for converter
currents
≤.
800 A，选择
L13
and for converter currents > 800 A,
选项
L26
. For converters with power units connected in paral-
lel, electrical separation from the line supply is included as stan-
达德。
L60
EMERGENCY STOP Category 1, 24 V DC
EMERGENCY STOP Category 1 for controlled stopping accord-
ing to EN 60204-1.
The function stops the drive using a fast stop along a down ramp
由用户参数化。电源给了
然后按照紧急情况进行中断验证器
类别0。
为了保持指定的停止时间，它可能是nec-
使用制动单元的敏感。
注意：
Option
L60
always requires electrical separation from the line
供应,这意味着一个中国保监会的转换器uit, for converter
currents
≤.
800 A，选择
L13
and for converter currents > 800 A,
选项
L26
. For converters with power units connected in paral-
lel, electrical separation from the line supply is included as stan-
达德。
终端
-X240:
意义
1
L1 (110 ... 230 V AC)
2
N
3
PE
终端
-X120:
意义
7
循环在植物侧的按钮上的紧急情况下;
删除跳线7-8！
8
循环在植物侧的按钮上的紧急情况下;
删除跳线7-8！
15
监测开始的“开启”;删除跳线15-16！
16
监测开始的“开启”;删除跳线15-16！
17
Checkback signal, "Safety combination has tripped"
18
Checkback signal, "Safety combination has tripped"
终端
-X120:
意义
7
循环在植物侧的按钮上的紧急情况下;
删除跳线7-8！
8
循环在植物侧的按钮上的紧急情况下;
删除跳线7-8！
15
"On" for manual start; remove jumper 15-16!
16
"On" for manual start; remove jumper 15-16!
17
Checkback signal, "Safety combination has tripped"
18
Checkback signal, "Safety combination has tripped"
终端
-X120:
意义
7
循环在植物侧的按钮上的紧急情况下;
删除跳线7-8！
8
循环在植物侧的按钮上的紧急情况下;
删除跳线7-8！
15
"On" for manual start; remove jumper 15-16!
16
"On" for manual start; remove jumper 15-16!
17
Checkback signal, "Safety combination has tripped"
18
Checkback signal, "Safety combination has tripped"
©Siemens AG 2015